HoMedics AR-NC01 Instruction for Use download pdf (Page 5)

8 9

Bottom of Remote

Power ON/OFF

Fan Speed

Timer

If the timer is set, the

white backlight of the

corresponding hour

setting will be on for

3 seconds and then

turn off.

Using the Remote Control

BEFORE FIRST USE, REMOVE PLASTIC PULL TAB FROM BATTERY COMPARTMENT.

Battery Installation

One CR2032 3V battery is included with the remote control. To change the battery,

remove the battery door at the back of the remote by squeezing the tab and pulling the

door away from the back of the remote. Please insert the battery into the remote with the

positive side up as shown on the drawer.

NOTE: Always keep the battery and remote control out of the reach of children.

BATTERY NOTE

• If the unit is not going to be used for a long period of time, remove batteries to

prevent damage due to possible battery leakage.

• Clean the battery contacts and also those of the device prior to battery installation.

• Remove used batteries promptly.

• Dispose of properly in accordance with all state, province, and country regulations.

• Do not dispose of batteries in ﬁre. Batteries may explode or leak.

• Use only the size and type of batteries speciﬁed.

• When installing batteries, observe proper polarity +/-. Improper installation of

batteries may cause damage.

Operating Instructions

1. On/Off and Speed Settings

1. To turn the air cleaner on, press the ON/OFF button. When the air cleaner is on,

the LED light will be lit and the air cleaner will start to operate on LOW speed.

2. There are four speed settings: Quiet (low) (medium) TURBO.

Quiet mode is whisper quiet – below normal room noise – and is recommended

particularly for night use and uninterrupted sleep. TURBO mode gives a cleaning

power boost. When the fan is set at TURBO, it will run for 30 minutes and then

return to (low) speed.

3. To turn the air cleaner OFF, simply press the ON/OFF again.

2. Timer Settings

There are four possible timer settings: 1 (one) hour, 4 (four) hours, 8 (eight) hours, and

12 (twelve) hours. To activate the timer, press the on the control panel. Each time

it is pressed, it will advance to the next timer setting. The timer LED will be illuminated

while the timer function is on. Cycle through 1, 4, 8, 12, then off to operate the unit

without the timer feature.

QUIET

TURBO

1hr 4hr

8hr 12hr

Fan Speed On/Off Clean Filter Timer Key

Control Panel

CLEAN

F I LT ER

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments

HoMedics AR-NC01 Instruction for Use Page 5

Comments to this Manuals